TOR application allows users to browse any sites, by bypassing firewall. So all the policies, rules configured in SRX goes in vain if users in the network are using TOR application in their browsers. Juniper SRX can’t block TOR application but there is a work around method that can be used to block TOR application […]
Logs are important feature that can be very handy to troubleshoot or monitor networks. You can configure firewall filters in various Juniper devices. Juniper’s SRX, EX, MX, T and other series devices support stateless firewall filters. Firewall filters are like access control lists (ACLs) in Cisco world. Firewall filters can be used to allow or […]
Dynamic VPN or Remote Access VPN is a feature available in branch series SRX. By default, branch series SRX gateways come pre-installed with two dynamic VPN licenses. So by default, only two remote users can have dynamic VPN simultaneously. You can purchase additional license for more dynamic VPN users. Dynamic VPN is used by users […]
Branch series Juniper SRX can operate at two different modes; packet mode and flow mode. In flow mode, SRX process all traffic by analyzing the state or session of traffic. In packet mode, SRX can process traffic as traditional router without analyzing the session of the traffic. By default, JunOS in SRX devices work at […]
In this post, I am going to talk about SRX 240 upgrade error. I was trying to upgrade SRX 240 H2 from JunOS 11.4R7.5 to JunOS 11.4R11.4. I got a Error saying, “Please install a package with version 11.4R5 or Higher”. SRX 240 Error! Install Package Version 11.4R5 or Higher! Here is the log of […]
Sometime Juniper devices may not boot JunOS properly. The image might be corrupted. So you need to re-install the JunOS of the EX or SRX device from the loader prompt. It is always good idea to have a USB snapshot of the JunOS device. But if you don’t have backup then you have to re install […]
If you have two ISPs or two different links for same destination, then you can configure floating static route. Floating static route allows you to failover the link if the primary link fails. This is accomplished by using preference and qualified-next hop feature available in JunOS operating system. To configure dual ISP link failover in […]